I hate to clutter forum with little questions...
I'm finally getting to the DC conversion and a bit confused how i should run the wires out of the case, to the R/R?
The stock wires pass through a sealed grommet and shrink wrap.
Originally i thought i would splice the new yellow wire with the existing black wire, but im realizing that black ground which attaches to stator plate must stay intact for the ignition coil, correct?
So floating the ground just means to send 2 yellow wires off the lighting coil and outside the case to the R/R, correct?
Thank you.
--
Additionally, once i have the battery set up, can i run from the battery red back to the existing red wire that connects to the light switch, or are there other places where the wiring harness grounds to frame that i must avoid? So i can't use the original harness at all for the lighting circuit?
My first thought was to run the red from battery through light switch to join a "Y" connection with the red bullet connectors behind the headlight.
--
Lastly, is there a specific R/R i need, for specs, or just a 12V.
