Help with washer location after case splitting
-
- Member
- Posts: 5
- Joined: 11:34 am Jan 28 2019
- Country: United States
Help with washer location after case splitting
I just split the case on my 05 220 because the Piston skirt broke then cracking the left case. After splitting the case a washer dropped out. I checked the manual and exploded transmission view but can't seem to locate it. It only fits the input shaft where it enters the bearing the right case. Here is a picture where it may go. Is this correct? Also, should I buy just the left case or find a matching set? Thanks for your time!
- Attachments
-
- 15853419059661888004114.jpg (1.99 MiB) Viewed 2081 times
-
- Member
- Posts: 5
- Joined: 11:34 am Jan 28 2019
- Country: United States
Re: Help with washer location after case splitting
Found it...I guess it was stuck behind clutch basket and I missed it. Bumping the case with a rubber mallet while splitting the case must have caused it to fall off.
-
- Supporting Member
- Posts: 739
- Joined: 08:28 am Apr 21 2019
- Country: United States
- Location: North Cackalack
Re: Help with washer location after case splitting
Glad you got it. Usually cases are machines for each other, so a matched set is the way to go.
I like turtles
- Molly's 70
- Platinum Member
- Posts: 638
- Joined: 04:29 pm Jun 18 2017
- Country: USA
- Location: Wichita, Kansas USA
Re: Help with washer location after case splitting
I would try to TIG weld the cracked case.
If you lend someone $20, and never see that person again, it was probably worth it.
-
- Supporting Member
- Posts: 739
- Joined: 08:28 am Apr 21 2019
- Country: United States
- Location: North Cackalack
- Molly's 70
- Platinum Member
- Posts: 638
- Joined: 04:29 pm Jun 18 2017
- Country: USA
- Location: Wichita, Kansas USA
Re: Help with washer location after case splitting
Yes it sure would. I'd like to see a picture. I could be wrong but, I bet it can be welded.
If you lend someone $20, and never see that person again, it was probably worth it.
- Slick_Nick
- Supporting Member
- Posts: 1689
- Joined: 10:06 pm Oct 22 2009
- Country: Canada
- Location: Calgary, Alberta
- Contact:
Re: Help with washer location after case splitting
Yeah always replace them as a set, but if you can repair your cases without warping them it’s probably more cost effective.
'00 KDX 220R