Page 1 of 1
Daz from Down Under. 91KDX250 large bore.
Posted: 11:30 pm Nov 28 2018
by Daz
Thanks for adding me. I am 3/4 through spruce up. I have a 91 250 on largest bore (306 I'm told) Fresh bottom, Wiseco piston and rings, hot rod, and bearings. Rear guard upgrade, new lighting loom and controls, trailtech speedo and dash set, plenty more to come. I have a parts bike so I have two sets of wheels, will fit kendas to one set running 14/47 sprockets, and battlecross on the other pair running 13/48 for the tight singles and track days. I intend to register her for the road here in Melbourne, Australia. Cheers.
Engine No's. Build-JKADXME10MA000421
Parts-JKADXME16MA000861
Re: Daz from Down Under. 91KDX250 large bore.
Posted: 11:51 pm Nov 28 2018
by KDXGarage
Welcome to kdxrider.net. Good luck on the continued work!
Re: Daz from Down Under. 91KDX250 large bore.
Posted: 12:08 am Nov 29 2018
by Daz
Cheers, its a gold mine here. Hope to upload some pics soon and ask a few intelligent questions.
Re: Daz from Down Under. 91KDX250 large bore.
Posted: 01:08 am Nov 29 2018
by bufftester
Welcome to the forums! Lots of Aussies active on here.
Re: Daz from Down Under. 91KDX250 large bore.
Posted: 12:47 pm Dec 01 2018
by Daz
Cheers.
Re: Daz from Down Under. 91KDX250 large bore.
Posted: 07:17 pm Jan 18 2019
by Dan 250sr
Hello Daz , you wouldn't have a part number for piston they used? Would you know if yours is 70mm stroke to..
I've just had mine 265 cc , only because that was biggest piston I could find. Cheers ..