Daz from Down Under. 91KDX250 large bore.

[Daz]

Thanks for adding me. I am 3/4 through spruce up. I have a 91 250 on largest bore (306 I'm told) Fresh bottom, Wiseco piston and rings, hot rod, and bearings. Rear guard upgrade, new lighting loom and controls, trailtech speedo and dash set, plenty more to come. I have a parts bike so I have two sets of wheels, will fit kendas to one set running 14/47 sprockets, and battlecross on the other pair running 13/48 for the tight singles and track days. I intend to register her for the road here in Melbourne, Australia. Cheers.
Engine No's. Build-JKADXME10MA000421
Parts-JKADXME16MA000861

[KDXGarage]

Welcome to kdxrider.net. Good luck on the continued work!

[Daz]

Cheers, its a gold mine here. Hope to upload some pics soon and ask a few intelligent questions.

[bufftester]

Welcome to the forums! Lots of Aussies active on here.

[Daz]

Cheers.

[Dan 250sr]

Hello Daz , you wouldn't have a part number for piston they used? Would you know if yours is 70mm stroke to..
I've just had mine 265 cc , only because that was biggest piston I could find. Cheers ..