KLX 450r front end done
Posted: 11:25 am Jul 26 2025
Swapped over forks and triples from 2008 KLX 450r with 48mm KYB AOS forks. Used the Amazon conversion bearing as mentioned several times in the forum. Didn't have to add any shims to get the triples to fit appropriately.
Managed to use the KDX wheel/axle/odometer/brake caliper with a little shimming to center the wheel in the forks and a threaded round nut on caliper side to fit in axle hole, and an appropriately sized bushing for the other side. Still have to work over new brackets to use the KDX front fairing/light and odometer.
Riding around the yard had to drop the front end so forks are up 1/2" above triples for it to feel like front end was in same position as topped out KDX forks. Going for a ride today, hoping to get a feel for if I need to make some shim adjustments.
Managed to use the KDX wheel/axle/odometer/brake caliper with a little shimming to center the wheel in the forks and a threaded round nut on caliper side to fit in axle hole, and an appropriately sized bushing for the other side. Still have to work over new brackets to use the KDX front fairing/light and odometer.
Riding around the yard had to drop the front end so forks are up 1/2" above triples for it to feel like front end was in same position as topped out KDX forks. Going for a ride today, hoping to get a feel for if I need to make some shim adjustments.