Hoses 2021 - brakes and rads
Posted: 12:22 pm Jul 19 2021
2003 KDX 200…
Having recently done a super fresh top end with porting, Rev pipe, Fredette’s torque ring and jetting, Boyesen Radvalve upgrade, fresh clutch plates, Racetech Springs (thanks Doug!!) and and many other mods and improvements, I’m eyeballing the next round of upgrades. Maybe somethings to keep her from blowing up or out through a turn and into the trees?
My radiator hoses are nearing the end of their lifespan, so I’m naturally interested in some blingy blue silicone ones, but… I’ve read research from Gates (who also manufactures silicone hoses) that they are somewhat porous requiring you to really keep an eye on your water level. Also understand they can be more prone to slippage and leaks than rubber. Experience or brands you were happy with or to avoid? There’s some $20 chinese ones on Amazon that are molded for this bike.
While I’m at it I figure it’s about past time to get my brake hoses done too. The rear works fine, but I really hate the feel of the front one. Would consider plain stainless braided or blingy blue. Has anyone either done these recently and could offer experience-based recommendations? Planning to replace both ends at once.
Thanks!
Having recently done a super fresh top end with porting, Rev pipe, Fredette’s torque ring and jetting, Boyesen Radvalve upgrade, fresh clutch plates, Racetech Springs (thanks Doug!!) and and many other mods and improvements, I’m eyeballing the next round of upgrades. Maybe somethings to keep her from blowing up or out through a turn and into the trees?
My radiator hoses are nearing the end of their lifespan, so I’m naturally interested in some blingy blue silicone ones, but… I’ve read research from Gates (who also manufactures silicone hoses) that they are somewhat porous requiring you to really keep an eye on your water level. Also understand they can be more prone to slippage and leaks than rubber. Experience or brands you were happy with or to avoid? There’s some $20 chinese ones on Amazon that are molded for this bike.
While I’m at it I figure it’s about past time to get my brake hoses done too. The rear works fine, but I really hate the feel of the front one. Would consider plain stainless braided or blingy blue. Has anyone either done these recently and could offer experience-based recommendations? Planning to replace both ends at once.
Thanks!