Page 1 of 1
Clutch actuator not actuating
Posted: 05:37 pm Dec 04 2020
by JoshJHTX
Hey all! I’m putting my clutch cover back on and realize that I have very little clutch pull and after about 1/4 of an inch it is stiff. What I’m wondering is, does the clutch actuator arm have to go in a certain way and if my return spring is placed correctly thanks!
Re: Clutch actuator not actuating
Posted: 12:55 am Dec 08 2020
by bufftester
Your actuator looks to be correctly oriented. What did you torque your clutch spring bolts too? Did you remove the clutch while the cover was off?
Re: Clutch actuator not actuating
Posted: 11:34 pm Dec 09 2020
by tucker
Yeah i'd check the torque specs on your springs - if too tight can cause a tough pull. Also just check your cable slack.
Re: Clutch actuator not actuating
Posted: 01:25 pm Dec 11 2020
by decluk13
Why was the cover off? Any chance you installed EBC heavy duty springs? i had this happen to me and had to swap them for a new set of OEMs