Page 1 of 1
Shift lever and shift rod
Posted: 09:07 pm May 24 2016
by RockwoodKDX
Just tried to order a gear shift lever and shift rod for my 91 KDX 200. Shop called me back a week later and said shifter is on backorder and the rod is no longer made. Trying Babbitts next. Anyone have other suggestions for locating this? Part number 13161-1170
Thanks in advance.
Sent from my SM-N920V using Tapatalk
Re: Shift lever and shift rod
Posted: 09:43 pm May 24 2016
by patricktuller
Partzilla, you can enter oe part numbers in
Sent from my SM-G920P using Tapatalk
Re: Shift lever and shift rod
Posted: 01:28 am May 25 2016
by 6 Riders
Order parts for the 95-06, should be the same as the kdx bottom end didn't really change much.
Re: Shift lever and shift rod
Posted: 04:22 am May 25 2016
by RockwoodKDX
Thanks I will try one of these if it gets kicked back from Babbitts
Sent from my SM-N920V using Tapatalk
Re: Shift lever and shift rod
Posted: 05:26 am May 25 2016
by RockwoodKDX
Partzilla says the shaft is obsolete, will order the 95-06 part.
Sent from my SM-N920V using Tapatalk
Re: Shift lever and shift rod
Posted: 01:07 pm May 25 2016
by david
It's very possible that it's the same part. The difference that I can see is that the E series was sold as two different pieces, the shaft and pawl, separately. The H series was consolidated into one part number and the pieces show to be together on the parts drawing. There is a used H series on eBay for $30 and free shipping, that would be worth checking out. Maybe you can get a good enough look at it to compare to your to see if it will work.
http://www.ebay.com/itm/Shift-Lever-Sha ... Gx&vxp=mtr
Re: Shift lever and shift rod
Posted: 08:47 pm May 25 2016
by RockwoodKDX
Confirmed, shift shaft no longer made. Got a shaft from a KX125. It is a little shorter but seems like it will work fine.
Sent from my SM-N920V using Tapatalk
Re: Shift lever and shift rod
Posted: 05:16 pm May 26 2016
by RockwoodKDX
david wrote:It's very possible that it's the same part. The difference that I can see is that the E series was sold as two different pieces, the shaft and pawl, separately. The H series was consolidated into one part number and the pieces show to be together on the parts drawing. There is a used H series on eBay for $30 and free shipping, that would be worth checking out. Maybe you can get a good enough look at it to compare to your to see if it will work.
http://www.ebay.com/itm/Shift-Lever-Sha ... Gx&vxp=mtr
Thanks, did not see this until after I purchased one for KX. In looking at the two, I am glad I bought the one I did. It is in perfect condition and I bought it with a lever for $50 total. Both in excellent condition
Sent from my SM-N920V using Tapatalk