1979 KDX 400
Posted: 12:55 am Jun 23 2014
I have a very beat up 400 on my hands that I want to put back together and I want to plate it. A few problems, I have no swingarm and my engine may have low compression (100 psi dead cold) and the cylinder plating is pretty bad. These parts are rare, the piston and rings are even harder to find. Other than that I have pretty much everything else to put it back together. I have done a few non titled motorcycles through vermont but never an off road bike before. Has anyone gone this way? Im from PA so its quite hard to get anything titled thats not meant to be. Its not that big of a deal but I would like a dual sport especially a 2 stroke.



engine



excuse the mess my T350 decided to dump a bunch of trans oil from its neutral switch



engine



excuse the mess my T350 decided to dump a bunch of trans oil from its neutral switch