Page 1 of 1
91 kdx 250 fork seals
Posted: 01:06 pm Aug 20 2013
by brandonvick83
Im trying to change the fork seals in my kdx i can't find tool i need to hold cartridge while you break loose the allen head at the bottom. Can anyone tell me were i can find one or another way of doing it?
91 kdx 250 fork seals
Posted: 01:08 pm Aug 20 2013
by rbates9
Try an air gun to spin them apart.
Re: 91 kdx 250 fork seals
Posted: 01:58 pm Aug 20 2013
by sarrant
Motion pro '08-0117' works on your model.
Re: 91 kdx 250 fork seals
Posted: 03:33 pm Aug 20 2013
by KDXohio
+1 on the air impact
91 kdx 250 fork seals
Posted: 03:55 pm Aug 20 2013
by brandonvick83
Ya im sure the air impact will work getting them apart but torquing them back down is the problem
Re: 91 kdx 250 fork seals
Posted: 04:45 pm Aug 20 2013
by KDXohio
You can put them back in with the impact too as long as you start the threads by hand
Re: 91 kdx 250 fork seals
Posted: 07:46 pm Aug 20 2013
by royadams
You don't need to take it out to change just the seals. Only if you are going to take the shim stacks apart to clean. Just to do the seals just take off top cap, take dampening rod off of the cap, remove dust seal, remove clip on top of seal, grab the two half's and pull them apart. Then change seals.