Page 1 of 1
Pipe installation
Posted: 12:00 pm Mar 11 2011
by kdx78
Hey guys this might sound like a stupid question but I just got a gnarly rev pipe for my 03' kdx and was wondering how difficult it will be to put on. The bike is currently in storage so I figured I would ask before I break anything lol. Thanks
Posted: 12:07 pm Mar 11 2011
by scheckaet
really easy.
You may have to adjust some of the tabs but that's about it.
Posted: 12:27 pm Mar 11 2011
by kdx78
Are they bendable by hand or should they be heated up?
Posted: 12:41 pm Mar 11 2011
by scheckaet
no need for heat.
Posted: 04:05 pm Mar 11 2011
by rbates9
The "tabs" (that I think he is talking about) have a bolt in one that goes into the frame and a bolt in the other that goes into the pipe. Just loosen them up from the frame when you put the new pipe on and once everything is started they should tighten up good. The new pipe may not fit just like the old one but should be fine.
Posted: 09:12 pm Mar 28 2011
by kdx78
Thanks a lot guys it went on with no issues