KDXRIDER.NET

here are some pics.

Cartridge
[img][img]http://i347.photobucket.com/albums/p449 ... ure412.jpg[/img][/img]

These are the spots where I drilled
[img][img]http://i347.photobucket.com/albums/p449 ... ure407.jpg[/img][/img]

Piston rod assembly
[img][img]http://i347.photobucket.com/albums/p449 ... ure417.jpg[/img][/img]

Valve once taken apart
[img][img]http://i347.photobucket.com/albums/p449 ... ure408.jpg[/img][/img]

I'd like to specify that I drilled and heated because I wasn't sure what I was doing and that it may be possible to do this without drilling.

Like this...

Where did you get that?

From your link you originally posted....

This thread has gone private?

Is there something to be understood from the previous three posts?

..in which case, kin someone 'splain it to me?

Thanks.

The pic of my bike was a test that did not work, so I tried again and got it to work with the pics of the insides of my fork. While I was doing all this Inda posted the pic of my bike.

I'm gonna try and make a gallery so I can post all the pics of my tear down.

'Be no longer afraid!'

...you kin do it!



Then you will be 'qualified' as a gallery owner, too!!