Re: Hi everybody from Scotland
Posted: 06:50 pm May 17 2018
Yep that’s what has been previously used and will be on the replacement hose,thanks for the input [emoji1303][emoji1303][emoji1303]cornishwrecker220 wrote:Just a small note....
If I were you I'd place some clips on the oil feed pipe where it joins the brass knuckles ...this will ensure the oil pipe is a nice tight fit & won't allow any air in should the pipe harden over time .... The type of clips like the ones used on the carb overflow/breather pipe should be fine.
Sent from my iPhone using Tapatalk