Page 2 of 2

About to Start

Posted: 07:24 am May 24 2018
by jstcraig
Image
The princely sum of the fuel for the trip to get the two of them, do the 91 they said will be easier than the 83 [emoji23][emoji23]
A leak/weep Same same [emoji1303]

Sent from my iPad Imageusing Tapatalk

About to Start

Posted: 01:46 am May 25 2018
by jstcraig
Well I would up load a video of the beast running but it won’t let me,so it runs not very well but it runs, only runs with the choke up so the carb rebuild was a fail, and the rattle from the engine is not good, sounds like loose timing chain.
I still nursed it up the street and back between showers so the clutch and g/box is good.
The suspension is shagged but livable but the motor rattle is not good [emoji20]


Sent from my iPhone using Tapatalk

Re: About to Start

Posted: 03:09 am May 25 2018
by jstcraig
Have a listen to this, you might get a laugh out of it,


Sent from my iPad using Tapatalk

About to Start

Posted: 03:22 am May 25 2018
by jstcraig
This was the first run, just learning how to upload so forgive the second vid



Sent from my iPad using Tapatalk

Re: About to Start

Posted: 05:52 am May 25 2018
by KDXGarage
My computer just tries to save them??

Re: About to Start

Posted: 08:59 am May 25 2018
by jstcraig
don't suppose you looked at the vid ???

Re: About to Start

Posted: 04:42 pm May 25 2018
by KDXGarage
When I click on the links, my computer tries to save the files, not view them.

Re: About to Start

Posted: 05:03 pm May 25 2018
by jstcraig
Oh, so I jst watched a few different vids on YouTube and the noise that was tripping me seems to be stock across all of them, it has been a long time since my Kx/Rm days, will have another run at the carb to day, another run through the cleaner won’t hurt it


Sent from my iPhone using Tapatalk

Re: About to Start

Posted: 03:16 am May 26 2018
by jstcraig
re did the carb set the needle one notch leaner and wound the needle jet out one turn, float height is 19mm, runs with out choke but the idle is inconsistent and difficult balance, it seems to lean now so I will lift the needle one space then try again.

About to Start

Posted: 08:37 am May 26 2018
by jstcraig
Kips Rattle [emoji849] maybe I should have read some more posts before I worried about that noise hopefully
Ok lifted the needle one notch and it’s better still has inconsistent idle but it improves as it gets warm. Now to sort out the petcock, wish they left enough room for a inline filter.



Sent from my iPhone using Tapatalk