kdx 250 1994 few questions
Posted: 01:36 pm Jun 14 2023
reporsted from usa kdx250 section............
I have a 93 kdx250 which I recently bought to restore. Its all looks fairly original and looks like the 6000 miles showing is correct , downside is it's been left outside for a long time so plenty of work to do.
Can anyone answer the following queries .................
Was the original swing arm bare aluminium or was it painted ?
The bike has not been started for 8 years but has great compression and after I de-rust the tank I want to try and start it. The autolube still has oil in it and the oil feed line is full, so before I start it is there anyway to make 100% sure the autolube is working and feeding the engine ?
Same with the engine coolant, its showing half way in the rear reservoir and you can see it in the rad, should I go ahead and start it or any suggestions of checks etc to see if it working ?
I am not going to respray the frame, but there are rusty scuffs around footpeg area of frame and I want to fit some new green frame protectors. I have seen them for the kdx200 but not kdx250, anyone got any ideas ?
Lastly , any tips for getting the swing arm out ?
Thanks Mike
I have a 93 kdx250 which I recently bought to restore. Its all looks fairly original and looks like the 6000 miles showing is correct , downside is it's been left outside for a long time so plenty of work to do.
Can anyone answer the following queries .................
Was the original swing arm bare aluminium or was it painted ?
The bike has not been started for 8 years but has great compression and after I de-rust the tank I want to try and start it. The autolube still has oil in it and the oil feed line is full, so before I start it is there anyway to make 100% sure the autolube is working and feeding the engine ?
Same with the engine coolant, its showing half way in the rear reservoir and you can see it in the rad, should I go ahead and start it or any suggestions of checks etc to see if it working ?
I am not going to respray the frame, but there are rusty scuffs around footpeg area of frame and I want to fit some new green frame protectors. I have seen them for the kdx200 but not kdx250, anyone got any ideas ?
Lastly , any tips for getting the swing arm out ?
Thanks Mike