KDXRIDER.NET

Yoooo what's up guys,

I'm finishing up the restoration job on my 2002 KDX 200 and am down to the last few things I need to replace which includes a cracked throttle tube. I found a few plastic replacements, but also noticed there is a moose billet throttle tube for the KDX line that looked interesting as I've never had an issue with my Zeta billet tube on my DRZ400S.

Has anyone tried the moose billet throttle tube on their KDX and have any feedback, good or bad, that you can share?

Thanks!!

How much is the part?

Around $40, so just a bit more over the cost of the stock tube at my local dealer which will run me about $36 for the throttle tube and wheel (46019-1054 and 59101-1103)

I switched to these grips a while back and will never mess with glue again. They include the throttle tube. Just another option for you.

http://odigrips.com/store/emig-v2-lock-on-grips-2701

You will have to purchase the cam separately....see the application guide.

Cam L is the one you need if you go this route

Is Cam L a direct fit? I have Pro Taper lock ons and had to trim the cam in order for it to work.

yes the L is the direct fit.