Help with washer location after case splitting

Discussion specific to the 1995 - 2006 KDX200 (H Series) and 1995 - 2005 KDX220R (A Series) models sold in the USA
Post Reply
Chevydawg1
Member
Posts: 5
Joined: 11:34 am Jan 28 2019
Country: United States

Help with washer location after case splitting

Post by Chevydawg1 »

I just split the case on my 05 220 because the Piston skirt broke then cracking the left case. After splitting the case a washer dropped out. I checked the manual and exploded transmission view but can't seem to locate it. It only fits the input shaft where it enters the bearing the right case. Here is a picture where it may go. Is this correct? Also, should I buy just the left case or find a matching set? Thanks for your time!
Attachments
15853419059661888004114.jpg
15853419059661888004114.jpg (1.99 MiB) Viewed 1907 times
Chevydawg1
Member
Posts: 5
Joined: 11:34 am Jan 28 2019
Country: United States

Re: Help with washer location after case splitting

Post by Chevydawg1 »

Found it...I guess it was stuck behind clutch basket and I missed it. Bumping the case with a rubber mallet while splitting the case must have caused it to fall off.
kdxsully
Supporting Member
Posts: 739
Joined: 08:28 am Apr 21 2019
Country: United States
Location: North Cackalack

Re: Help with washer location after case splitting

Post by kdxsully »

Glad you got it. Usually cases are machines for each other, so a matched set is the way to go.
I like turtles
User avatar
Molly's 70
Platinum Member
Platinum Member
Posts: 563
Joined: 04:29 pm Jun 18 2017
Country: USA
Location: Wichita, Kansas USA

Re: Help with washer location after case splitting

Post by Molly's 70 »

I would try to TIG weld the cracked case.
If you lend someone $20, and never see that person again, it was probably worth it.
kdxsully
Supporting Member
Posts: 739
Joined: 08:28 am Apr 21 2019
Country: United States
Location: North Cackalack

Re: Help with washer location after case splitting

Post by kdxsully »

Molly's 70 wrote: 04:01 am Mar 28 2020 I would try to TIG weld the cracked case.
Wouldn’t that depend on location?
I like turtles
User avatar
Molly's 70
Platinum Member
Platinum Member
Posts: 563
Joined: 04:29 pm Jun 18 2017
Country: USA
Location: Wichita, Kansas USA

Re: Help with washer location after case splitting

Post by Molly's 70 »

kdxsully wrote: 07:37 am Mar 28 2020
Molly's 70 wrote: 04:01 am Mar 28 2020 I would try to TIG weld the cracked case.
Wouldn’t that depend on location?
Yes it sure would. I'd like to see a picture. I could be wrong but, I bet it can be welded.
If you lend someone $20, and never see that person again, it was probably worth it.
User avatar
Slick_Nick
Supporting Member
Posts: 1675
Joined: 10:06 pm Oct 22 2009
Country: Canada
Location: Calgary, Alberta
Contact:

Re: Help with washer location after case splitting

Post by Slick_Nick »

Yeah always replace them as a set, but if you can repair your cases without warping them it’s probably more cost effective.
'00 KDX 220R
Post Reply