Shock shim size
-
- Member
- Posts: 430
- Joined: 07:51 am Dec 28 2017
- Country: thailand
- Location: Thailand
Shock shim size
I'm going to use the shims from a Wr450 shock but I need to sand them down from 40mm to 38mm. Before I do that just want to confirm the ID hole of the shim is the same as the kdx. Measures 12mm?
- Attachments
-
- IMG_20200701_163932.jpg (1.03 MiB) Viewed 1554 times
-
- IMG_20200701_163907.jpg (1 MiB) Viewed 1554 times
1999 KDX220SR (KDX220-B5)
-
- Member
- Posts: 126
- Joined: 09:04 am Sep 23 2014
- Country: United States
- Location: TX born and raised.
Re: Shock shim size
I just rebuilt my rear shock and I know I ordered a 14mm rubber bumper. Seems like the piston and seal head were the same.
I also put in some SPLS14 race tech shims. So, I'll go with the KDX is 14mm
I also put in some SPLS14 race tech shims. So, I'll go with the KDX is 14mm
NEVER FORGET!
-
- Member
- Posts: 430
- Joined: 07:51 am Dec 28 2017
- Country: thailand
- Location: Thailand
Re: Shock shim size
On the kdx 14mm is the shaft size, Wr450 shaft size is 16mm, if the shims were the same size as the shaft then how are they held in position
1999 KDX220SR (KDX220-B5)
- KDXGarage
- KDXRider.net
- Posts: 14061
- Joined: 06:45 am Nov 01 2004
- Country: United States of America
- Location: AL, USA
- Contact:
Re: Shock shim size
The portion of the shaft where the shims and stuff go is 12 mm. The shiny chrome portion is 14 mm on the last few models of KDX's.
That piston band looks quite worn. If one can see the wear line from the o-ring(s) underneath, that is not too hot.
That piston band looks quite worn. If one can see the wear line from the o-ring(s) underneath, that is not too hot.
Thank you for participating on kdxrider.net.
To post pictures from a device: viewtopic.php?f=88&t=24128
To post pictures from a device: viewtopic.php?f=88&t=24128
-
- Member
- Posts: 430
- Joined: 07:51 am Dec 28 2017
- Country: thailand
- Location: Thailand
Re: Shock shim size
OK thanks, 12mm as in the first photo, this is the Wr450 shock and shim stack, my kdx is in Thailand and I am in Australia so I don't have a kdx shock to measure
1999 KDX220SR (KDX220-B5)
- KDXGarage
- KDXRider.net
- Posts: 14061
- Joined: 06:45 am Nov 01 2004
- Country: United States of America
- Location: AL, USA
- Contact:
Re: Shock shim size
1995 KDX200 shock valving
I used to fool with them.
I used to fool with them.
Thank you for participating on kdxrider.net.
To post pictures from a device: viewtopic.php?f=88&t=24128
To post pictures from a device: viewtopic.php?f=88&t=24128