Snap ring
- SS109
- KDXRider.net
- Posts: 5770
- Joined: 05:11 am Aug 23 2009
- Country: USA
- Location: Tucson, AZ, USA
- Contact:
Re: Snap ring
I always put the flat side to the outside.
Youtube Channel: WildAzzRacing
AZ State Parks & Trails OHV Ambassador - Trail Riders of Southern AZ
Current KDX: '98 KDX220
Old KDX: '90 KDX200 -White/Blue
'11 GasGas EC250R
AZ State Parks & Trails OHV Ambassador - Trail Riders of Southern AZ
Current KDX: '98 KDX220
Old KDX: '90 KDX200 -White/Blue
'11 GasGas EC250R
-
- Gold Member
- Posts: 875
- Joined: 06:59 am Jan 27 2017
- Country: US
- Location: Florida
Re: Snap ring
I'm with SS. The flat side always facing the same direction that you would slide the gear if you were removing it.
-
- Member
- Posts: 41
- Joined: 02:29 pm Jun 11 2019
- Country: England
Re: Snap ring
Me being a bit slow here so flat side is towards engine shaped side to front sprocket on all cheers.Wonder if anybody else was aware of this I only realised when Kawasaki dealer informed me
- SS109
- KDXRider.net
- Posts: 5770
- Joined: 05:11 am Aug 23 2009
- Country: USA
- Location: Tucson, AZ, USA
- Contact:
Re: Snap ring
No, flat side facing outward. That way it is a hard square edge against the groove holding on your sprocket.
Youtube Channel: WildAzzRacing
AZ State Parks & Trails OHV Ambassador - Trail Riders of Southern AZ
Current KDX: '98 KDX220
Old KDX: '90 KDX200 -White/Blue
'11 GasGas EC250R
AZ State Parks & Trails OHV Ambassador - Trail Riders of Southern AZ
Current KDX: '98 KDX220
Old KDX: '90 KDX200 -White/Blue
'11 GasGas EC250R
-
- Member
- Posts: 41
- Joined: 02:29 pm Jun 11 2019
- Country: England
Re: Snap ring
Got it I think all 4 snap rings on the output shaft have flat side to sprocket
- KDXGarage
- KDXRider.net
- Posts: 14047
- Joined: 06:45 am Nov 01 2004
- Country: United States of America
- Location: AL, USA
- Contact:
Re: Snap ring
all 4??
Thank you for participating on kdxrider.net.
To post pictures from a device: viewtopic.php?f=88&t=24128
To post pictures from a device: viewtopic.php?f=88&t=24128
-
- Member
- Posts: 41
- Joined: 02:29 pm Jun 11 2019
- Country: England
Re: Snap ring
Yes rebuilding engine there are 3 inside engine on sprocket shaft
- KDXGarage
- KDXRider.net
- Posts: 14047
- Joined: 06:45 am Nov 01 2004
- Country: United States of America
- Location: AL, USA
- Contact:
Re: Snap ring
OH. OK. I was thinking outside the engine.
Thank you for participating on kdxrider.net.
To post pictures from a device: viewtopic.php?f=88&t=24128
To post pictures from a device: viewtopic.php?f=88&t=24128