Hey fellas,
Been working on things little by little.
Could not get on this site since Friday! Had me worried.
Here is a shroud shot
![Image](http://kdxrider.net/forums/modules/albums/Tha_reids/shroud.jpg)
Bad photo
![Image](http://kdxrider.net/forums/modules/albums/Tha_reids/full.jpg)
Front
![Image](http://kdxrider.net/forums/modules/albums/Tha_reids/front.jpg)
Sorry for the lg. photos!
I have some slight changes to make but overall I'm satisfied.
one shroud is approx. 1" taller than the exhaust side. [sarcasm]I'm sure our bikes totally benefit tremendously from that extra 1" piece of plastic down there[/sarcasm]
![DOH :doh:](./images/smilies/eusa_doh.gif)
I just saw your post KDXer as I'm writing this.
Ya know, with the equipment I use to print these, I have a 11.8" limit in one direction. I would like to make that the height, like the set for the 250.
So I work within a 11.8" by X length (X is endless) area. The 250 shroud graphic is only a 20 linear inch print which lowers the final cost.
As far as "what we can do" it's endless. Fork graphic, no problem.
KDXer,
You could just flip the smaller template, line it up, add some paper to the bottom without altering the template, then trace the additional area at the bottom. I will still see the small on one side and the large one on the other side.
Keep up the good work!