VForce3 on an '84 KDX200
-
- Supporting Member II
- Posts: 34
- Joined: 12:58 pm Dec 28 2019
- Country: United States
VForce3 on an '84 KDX200
I put a VForce3 reed system on my '84 KDX200 and noticed the "vane" in the new reed cage doesn't line up with the stock intake boot. I rotated the vane 180 degrees and have a similar result. Is this normal for these VForce systems?
- Attachments
-
- IMG_1418.jpg (1.75 MiB) Viewed 2673 times
-
- IMG_1422.jpg (2.44 MiB) Viewed 2673 times
- KDXGarage
- KDXRider.net
- Posts: 14047
- Joined: 06:45 am Nov 01 2004
- Country: United States of America
- Location: AL, USA
- Contact:
Re: VForce3 on an '84 KDX200
Did Moto Tassinari say it was for a 1984 KDX200??
Thank you for participating on kdxrider.net.
To post pictures from a device: viewtopic.php?f=88&t=24128
To post pictures from a device: viewtopic.php?f=88&t=24128
-
- Supporting Member II
- Posts: 34
- Joined: 12:58 pm Dec 28 2019
- Country: United States
Re: VForce3 on an '84 KDX200
Yes they did. I sent them a note and they responded today with the recommendation to "port" the air guide. I did that with a Dremel and it looks pretty good. Just a bit surprised they didn't mention that in the installation instructions.
- KDXGarage
- KDXRider.net
- Posts: 14047
- Joined: 06:45 am Nov 01 2004
- Country: United States of America
- Location: AL, USA
- Contact:
Re: VForce3 on an '84 KDX200
I guess that is about all you could do. Throw a pic up if you can.
Thank you for participating on kdxrider.net.
To post pictures from a device: viewtopic.php?f=88&t=24128
To post pictures from a device: viewtopic.php?f=88&t=24128
-
- Supporting Member II
- Posts: 34
- Joined: 12:58 pm Dec 28 2019
- Country: United States
Re: VForce3 on an '84 KDX200
Here are the "after" pictures after porting the VForce air guide. My technique was with a Dremel on the hard plastic material, finished with 600 emory paper. The surface feels pretty smooth to the touch, so hopefully no unwanted turbulence will be created.
- Attachments
-
- IMG_1430.jpg (3.87 MiB) Viewed 2636 times
-
- IMG_1431.jpg (1.71 MiB) Viewed 2636 times
- KDXGarage
- KDXRider.net
- Posts: 14047
- Joined: 06:45 am Nov 01 2004
- Country: United States of America
- Location: AL, USA
- Contact:
Re: VForce3 on an '84 KDX200
Hey, looks much better!
Thank you for participating on kdxrider.net.
To post pictures from a device: viewtopic.php?f=88&t=24128
To post pictures from a device: viewtopic.php?f=88&t=24128