A quick search didn’t come up with anything.
What’s the procedure for breaking in a new top end on an air cooled? Is it the same 15 min heat cycles? I presume that’s not good for an air cooled to idle in place for 15 minutes. But, I don’t know. That’s why I’m asking. Thanks for any help!
Air cooled top end break in
-
- Supporting Member
- Posts: 739
- Joined: 08:28 am Apr 21 2019
- Country: United States
- Location: North Cackalack
Air cooled top end break in
I like turtles
- KDXGarage
- KDXRider.net
- Posts: 14078
- Joined: 06:45 am Nov 01 2004
- Country: United States of America
- Location: AL, USA
- Contact:
Re: Air cooled top end break in
I would do a five minute warm up, then completely cool
five minute warm up and five minute cautious ride, complete cool down
five minute warm up and ten minute cautious ride, then complete cool down
varying throttle, but not lugging or revving it out too hard
I wouldn't do it any different than a liquid cooled KDX
five minute warm up and five minute cautious ride, complete cool down
five minute warm up and ten minute cautious ride, then complete cool down
varying throttle, but not lugging or revving it out too hard
I wouldn't do it any different than a liquid cooled KDX
Thank you for participating on kdxrider.net.
To post pictures from a device: viewtopic.php?f=88&t=24128
To post pictures from a device: viewtopic.php?f=88&t=24128
-
- Supporting Member
- Posts: 739
- Joined: 08:28 am Apr 21 2019
- Country: United States
- Location: North Cackalack
Re: Air cooled top end break in
Thanks!KDXGarage wrote: ↑06:35 pm Aug 02 2019 I would do a five minute warm up, then completely cool
five minute warm up and five minute cautious ride, complete cool down
five minute warm up and ten minute cautious ride, then complete cool down
varying throttle, but not lugging or revving it out too hard
I wouldn't do it any different than a liquid cooled KDX
I like turtles