1986 float adjustment.....
Posted: 11:29 am Mar 26 2019
So, I see where the manual states, 17mm, on float height. And, I know I measure the tang ears/arms, whatever they need to be called, from the gasket surface. But, do I need to have the carb somewhat at an angle, so that the tang is just seating on the float valve, not pressing it?
I have also been told to simply view it with the carb off the bike, upside down, and the tang ears should be parallel with body of the carb gasket, and this is the correct height...Thoughts???
I have also been told to simply view it with the carb off the bike, upside down, and the tang ears should be parallel with body of the carb gasket, and this is the correct height...Thoughts???