Exhaust valve installation

Discussion specific to the 1989 - 1994 (E Series) KDX200 model sold in the USA
Post Reply
ccdsg
Member
Posts: 24
Joined: 06:48 pm Jun 28 2020
Country: United States

Exhaust valve installation

Post by ccdsg »

So I took off my cylinder head, had it shipped off for replating, it will be back eventually and when it returns I will also have to install brand new steel valves. I was unable to figure out how to even get the valve system apart, I can't find many resources online that make sense to me. If anyone can give me some help here that would be wonderful.
User avatar
KDXGarage
KDXRider.net
KDXRider.net
Posts: 14047
Joined: 06:45 am Nov 01 2004
Country: United States of America
Location: AL, USA
Contact:

Re: Exhaust valve installation

Post by KDXGarage »

Have you tried Cyclepedia?
Thank you for participating on kdxrider.net. :bravo:
To post pictures from a device: viewtopic.php?f=88&t=24128
ccdsg
Member
Posts: 24
Joined: 06:48 pm Jun 28 2020
Country: United States

Re: Exhaust valve installation

Post by ccdsg »

I’ve been hearing a lot about the actuator lever and the arm, and needing to support that when messing with the valves. However when I originally took the jug off to inspect the cylinder and piston I didn’t know anything about that. My jug has been off for a while and I’m not sure how to tell if I broke the pin off the arm that’s inside the clutch. Can anyone show me an image of what these are?
eastenkdx
Member
Posts: 5
Joined: 04:01 am Aug 27 2021
Country: New Zealand

Re: Exhaust valve installation

Post by eastenkdx »

16300564488823748781611318913970.jpg
16300564488823748781611318913970.jpg (1.31 MiB) Viewed 2338 times
Post Reply