Suggestions please!!
-
- Member
- Posts: 36
- Joined: 08:03 pm Sep 07 2008
- Country:
Suggestions please!!
I have a chance to buy a complete, Less the engine, 2006 KX250F for $850. Would a KDX engine fit? I weld and fabricate, but not sure if the frame would line up for the exhaust pipe to mount. Anyone offer advice?
- m0rie
- Supporting Member I
- Posts: 2220
- Joined: 10:25 pm Nov 29 2004
- Country:
- Location: Crescent City, CA
You'll have to do some fab work but I bet it would work. It would certainly be a nice setup.
1989 KDX 200
2007 TTR-50E
2007 TTR-50E
-
- Member
- Posts: 36
- Joined: 08:03 pm Sep 07 2008
- Country:
Took a look at my 98 KDX220 and my 09 KX250F for the possibilities of the 06 KX250f frame and a KDX motor. The KXf has a single Aluminum down tube while the KDX has the split down tube for the exhaust. I'm kinda seeing a way to cut the KXF down tube and put in a donut shaped section where the pipe could go through the donut. Now the engine I'm looking at is a 93 KDX200. Is this a decent motor? Or should I hold out for a 220?
- fuzzy
- KDXRider.net
- Posts: 3437
- Joined: 01:29 pm Jun 18 2003
- Country:
- Location: Fredneck, MD