KDXRIDER.NET

seeking data for rear shock service ,,,primarily oil and gas specifications for reassembly......cheers

Manual says.. Oil fill to "about 60mm" from the gas resorvoir open end (shock upside down, pouring oil into the gas resorvoir). Then instal the Nitrogen bladder. Fill the shock body until the level is about 52mm from the shock body end.
After everything is together, fill the nitrogen bladder to 7psi, check for leaks. No leaks, fill it to 142psi, and your good to go.
I just took mine to the shop. Think it cost me $25 plus oil, and has worked great ever since.

OLHILLBILLY wrote:Manual says.. Oil fill to "about 60mm" from the gas resorvoir open end (shock upside down, pouring oil into the gas resorvoir). Then instal the Nitrogen bladder. Fill the shock body until the level is about 52mm from the shock body end.
After everything is together, fill the nitrogen bladder to 7psi, check for leaks. No leaks, fill it to 142psi, and your good to go.
I just took mine to the shop. Think it cost me $25 plus oil, and has worked great ever since.

good on ya mate.....much oblidged..........cheers