KDXRIDER.NET

I used plenty of sealer ??

This really pisses me off

LMAO! WTF IS THAT????

**** I followed directions and everthing!

Used the whole tube!

You used the wrong color. The yammie con rods need blue or black grilla snot, not silver.

Real question is why is there a yamaha Con. Rod in your KDX? :)

You can reuse that.

frankenschwinn wrote:Real question is why is there a yamaha Con. Rod in your KDX? :)

Maybe thats why it runs so strong?

why is there a need to use sealer when there is the gasket for it. nobody uses sealer on the top end. just the base gasket will do. and looking at the cond rod and the condition around the crank, think the bike is poorly maintain.

Thats why you have to use JB Weld instead. Guaranteed not to leak as long as you use the whole tube.

KDXsg wrote:why is there a need to use sealer when there is the gasket for it. nobody uses sealer on the top end. just the base gasket will do. and looking at the cond rod and the condition around the crank, think the bike is poorly maintain.

Cuz I dint have a gasket dummazz

Geez are yuse stoopid or sumpthin?????

Just squeeze on another tube. You'll be fine~

Have you tried really big hose clamps?

I did

I had some of this from another project, but I think it'll be ok

pot calling the kettle black. mr wibben, human being make gasket for a reason, if you think everything can be solved with sealant....a bit of common sense will tell NO! put that ego of yours down abit and admit that its a mistake of you to have use sealant for something as simple as that. There is no need to be rude and call me stupid when i think that applys to you too., if I am one...haha..have a good time then messing around that junk....

The entire post was tongue in cheek KDXsg... relax.....

How'd you guess ?

read the green warning disclaimer at the bottom of wibb's profile

That liquid nails stuff is the bomb.

It'll work better than than silver stuff.

However, if the problem is a water leak your bestest bet would be to cut your own gasket out of roofing felt and use tar on both sides.

IMO

I have my own special recipe. Never had a leaked yet!
[img][img]http://i802.photobucket.com/albums/yy30 ... tarpit.jpg[/img][/img]

Indawoods wrote: The entire post was tongue in cheek KDXsg... relax.....

You should have let him carry on, this was just getting entertaining!