KDXRIDER.NET

Hi,

I need to remove the lower triple tree taper bearing - it's shot but I cannot see how to do it without resorting to butchery!!

I have searched youtube (normally a good source for "how to" vids) but on this occasion drew a blank.

The kawa manual I have shows how to remove the taper cones from the frame and how to put the lower taper bearing on but in the strip down sequence simply says "remove the lower bearing"!!!

Any help would be much appreciated!!

Gert

Hammer... Chisel....

Thanks Indawoods!

I would like to remove it without damaging the stem or bottom triple tree - damage will result if I try the hammer chisel route!!

thought about using a dremel cutter then the chisel approach but i am not convinced!


cheers Gert

You shouldn't damage it if you are somewhat careful... I have never damaged the stem...