Page 1 of 1
Gear Levers.
Posted: 12:01 am Sep 25 2006
by cfspawn
Hey all.
Just wondering If anyone has had experiences with MCS gear levers. mines busted and looking to be replaced
they are quiet cheap compared to OEM and also other brands. i have also been told they are steel any comments would be appreciated.
Posted: 12:03 am Sep 25 2006
by KDXer
I think they are an aussie lever but I could be wrong.
Posted: 12:11 am Sep 25 2006
by cfspawn
Yer. for $25 AUD see what happens
Posted: 12:42 am Sep 25 2006
by KDXer
Sure beats the $65 I payed for my IMS replacement.
Posted: 01:27 am Sep 25 2006
by cfspawn
Could be a quality thing though Trev. soon find out
Posted: 06:48 am Sep 25 2006
by krazyinski
my OEM broke the spline clamp, is this normal ?
Posted: 05:46 pm Sep 25 2006
by cfspawn
Thats the problem with mine.
Posted: 12:09 am Sep 26 2006
by KDXer
And mine...
Posted: 08:07 am Sep 26 2006
by krazyinski
what I did was went and purchased a cheap lever MSR like and cut the spline clamp off of the oem and the new one and welded the new clamp on the old shifter. just use a bolt and two washers to protect the splines from slag, the oem bolt will hold it in the right spot then weld away.