KDXRIDER.NET

i just got a plate for my 03 220 i'm using a frp brakelight switch which uses the stock taillight what are guys using to mount your plate...
thank you
tom

I switched up the whole kit by putting on a Maier MX style rear fender and an Acerbis LED taillight with a plate holder on it. The MX fender allowed me to put on a Moose folding tool kit that is really nice too. If you look at Jeff's site you see the picture of the bike with the stock fender and a plate holder below it. It is the Acerbis rig I have. He sells them for $40. The reason why I switched the whole thing up was I did not want the add-on, cobbie look with two separate lights. The set up I have now looks so cool and clean. The stock light would go through lightbulbs like crazy too. The LED is bright yet uses less power so your headlight gets brighter as well. It is wired for a brake light switch. All you need is a few bullet style connectors and you can plug right in to the stock wiring harness. You can get the Maier fender from Jeff too.
Hey, I just noticed that your from NH. We should hook up and ride sometime. I live in Vermont, next to Stratton Mt.
If you would like to see a pic, I should get off my lazy butt and update my album. Maybe today since it is still raining.

Riding! Yeah, I belong to NETRA and just got the route sheets for the only 3 rides in Vermont. My Brother-in-law and I are planning on hitting all of them this summer and would be psyched to have one or two more riding buddies for the trips. They are in Southern Vermont on the eastern side of the state so a little closer to NH. We are into checking out what you guys have over your way too. We don't have an easy way to get bored here either. I have 5 or so different rides that leave right from my house on GPS. All of them are at least 40 miles of gnar-gnar!

KD-Are you going to the Reading Off Road Riders HS in Pennsylvania this sunday the 11th. Its an ECEA HS, but I have seen NETRA guys there.
http://www.ecea.org

http://www.rorr.org/index.htm

No, I can't. Leaving Friday for a week long camping trip with my wife and two boys. After this trip though, I will be stylin' and will start with the Rocktoberfast Enduro in Lee, Mass. I think it is the end of this month.

I just drilled two 1/4 holes near the base of the tail light on the rear fender and zip-tied my plate on. 67.7 miles later she is still hanging on. I ride by bike two miles to work each day and the local pigs aint looked twice. I'll report back later ...

http://www.scottsperformance.com/produc ... ike=Yamaha i found this to use the wr 250 or 450 are the same as an kdx 200 or 220