Gear drum
Posted: 04:08 am Jul 25 2019
Hi just rebuilding the kdx I did not take the gear drum out but are there any marks when assembling to align the selectors all fit in the runners
A lot of people say to just put the case in the oven.Parney wrote: 03:18 pm Jul 25 2019 Many thanks all that side done if that’s the case fighting with needle roller at minute tried heat tried bearing puller thing will not move soaking it in penetrating oil for 24 hours
Agreed. 275 - 300 degrees F. Use gloves & turn the case over on a piece of wood, smack it down to help. Inside bearings may still need the "slide hammer/puller tool" as I call it.kdxsully wrote: 07:23 pm Jul 25 2019A lot of people say to just put the case in the oven.Parney wrote: 03:18 pm Jul 25 2019 Many thanks all that side done if that’s the case fighting with needle roller at minute tried heat tried bearing puller thing will not move soaking it in penetrating oil for 24 hours