1994 KDX 200 Graphic Template
Posted: 05:15 am Mar 22 2018
These are just the scans at the moment - I've been meaning to do this for the bike for the last 3 years, - so rather than wait until I have a chance to clean up and vector them....
Thought I would share here and again when I do eventually sort out.
The scans should be at 100% - but for reference the business card should be 85mmx55mm when you are sizing up. :)
Tank graphic just needs flipped for other side.
One of the side plastics was just off the top of the page- I'm working to top of page as size.
Rear plastics were too long for one bit of paper - so have the front edge separate. - note, one side has a rubber grommet in the middle vent.
Hope this helps.... I'll be doing the tail piece when the bike comes back from having the engine rebuilt.
EDIT: Link to Flickr photos.
https://flic.kr/s/aHsmgiyxTN
Thought I would share here and again when I do eventually sort out.
The scans should be at 100% - but for reference the business card should be 85mmx55mm when you are sizing up. :)
Tank graphic just needs flipped for other side.
One of the side plastics was just off the top of the page- I'm working to top of page as size.
Rear plastics were too long for one bit of paper - so have the front edge separate. - note, one side has a rubber grommet in the middle vent.
Hope this helps.... I'll be doing the tail piece when the bike comes back from having the engine rebuilt.
EDIT: Link to Flickr photos.
https://flic.kr/s/aHsmgiyxTN