KDXRIDER.NET

Anyone know what the manual says is proper fuel float level setting for the 1986 200cc? (Mikuni)

manual says its non adjustable.

hbgod wrote:manual says its non adjustable.

Thank you very much for looking that up! That is very strange though. It has a tang for the needle valve. Hmm, oh well. If that's what the manual says then so be it

bob_jones wrote:Anyone know what the manual says is proper fuel float level setting for the 1986 200cc? (Mikuni)

This is what my '86-'88 Kawasaki manual says.



If you don't want to buy their special tool, this is from Mikuni
http://www.mikuni.com/pdf/vmmanual.pdf



Adjust the float level by bending the tang in contact with the needle and seat as you said.

KDX Geoff wrote:

bob_jones wrote:Anyone know what the manual says is proper fuel float level setting for the 1986 200cc? (Mikuni)

This is what my '86-'88 Kawasaki manual says.



If you don't want to buy their special tool, this is from Mikuni
http://www.mikuni.com/pdf/vmmanual.pdf



Adjust the float level by bending the tang in contact with the needle and seat as you said.

Hes right im not sure what i was reading before but looked in my manual today and it says to bend the tang on the plunger. i used a flathead.