KDXRIDER.NET

can anyone out there please post me a picture of a fuel line with a filter on it,installed, i cant seem to get it right so i need some tips please???

Can you zoom in on this?

No it goes out of focus ! But thanks!

Well, I just used a 2 inch fuel hose off of the petcock. Then used an inline fuel filter. The used about 8 to 10" of fuel line and curly qued it up to the carb inlet. I didn't try to make it a perfect direct route. Just coil up the line after the filter and keep it away from snags.

Bultaco, I edited your post above with the right gallery link. Click and it will open full res. You can do that just by using the "gallery" bbcode button.

Thanks, Julien....I learned something new today.

Note: I've used plastic fuel line (that gets hard and un-bendable over time) and fuel resistant chain saw grade rubber hose. Find the chain saw grade if you can.