KDXRIDER.NET

Searched all over the place, but not finding a definitive answer to my question.

I am working on jetting the carb and this is a good chance to put in my new throttle cable. The old one is starting to fray at the end that goes to the top of the carb.

Anwway, as it is routed now it seems to take too many bends for my liking. Is this the correct routing?

Check your pm :)

Hmmmm.

It says I am not authorised to read my Private Messages. I will have to look into that one....

As per the manual, that kinda looks correct. Its supposed to go over the frame bar but looks like it should be under that middle rad bolt. (you will have to check the top as your picture doesn't show). Here is s link to a picture of the manual. I'm at work now, but can take picture for you later.

https://www.google.com/search?q=kdx+thr ... jYSTN4M%3A

Mario