crank thread size.
Posted: 05:12 am Jan 11 2016
looking for what the thread size is on the 02 kdx 200 crank ?
Which side?atvman2010 wrote:looking for what the thread size is on the 02 kdx 200 crank ?
Page 1 of 1
crank thread size.
Posted: 06:42 am Jan 11 2016
Re: crank thread size.
Posted: 09:34 pm Jan 11 2016
clutch basket side.
crank thread size.
Posted: 10:44 pm Jan 11 2016
Not sure on the pitch but it is a 16mm nut 92015-1581 is the part #
Re: crank thread size.
Posted: 07:40 pm Jan 12 2016
ok thanks, I found a tusk crank installer but i wanted to make sure its going to fit the seller not sure if it will. found on eaby.
Re: crank thread size.
Posted: 03:55 pm Jan 14 2016
I had a Pit Posse puller which I believe is the same thing - just a different name slapped on it.atvman2010 wrote:ok thanks, I found a tusk crank installer but i wanted to make sure its going to fit the seller not sure if it will. found on eaby.
Anyway, it didn't come with the correct adapter for the clutch side. But I just ground down an extra nut and turned it into an adapter.
I thought I had the thread size, but I don't.
Re: crank thread size.
Posted: 04:08 pm Jan 14 2016
"I thought I had the thread size, but I don't."
2nd best quote ever....
2nd best quote ever....
Re: crank thread size.
Posted: 04:13 pm Jan 14 2016
I was thinking the same thing about yours from another thread:6 Riders wrote:2nd best quote ever....
6 Riders wrote:*side note...I'm drunk, so try to read what I'm trying to say, instead of what I actually type
Re: crank thread size.
Posted: 04:22 pm Jan 14 2016
Perhaps a signature in that? 
Re: crank thread size.
Posted: 04:24 pm Jan 14 2016
of course now that I've read my own quote.....It was pretty good eh?Tedh98 wrote:I was thinking the same thing about yours from another thread:6 Riders wrote:2nd best quote ever....
6 Riders wrote:*side note...I'm drunk, so try to read what I'm trying to say, instead of what I actually type
Re: crank thread size.
Posted: 09:49 pm Jan 16 2016
thanks i'll give it a try