Page 1 of 1
94 kdx 200 top end seems flat?
Posted: 04:52 pm Oct 26 2014
by JoKa_603
I just recently picked up a kdx for cheap off Craig's list and after cleaning carb etc because it was sitting for a long time, I took it for a couple rips and it starts right up runs like a beast in low 2 mid but it seems when I get high in rpm it doesn't feel and different than mid just revs higher. I have been riding my 450 for the last couple months and I also have a done up blaster.. Could it just be me expecting more? All stock other than power core silencer. Are the kdx motors just not power monsters up top when stock?
Thanks
Nick
Re: 94 kdx 200 top end seems flat?
Posted: 02:07 am Oct 27 2014
by Bitteeinit
I'm by no means an expert, but maybe it's time for a new top end or more likely your power valves are gone.
Re: 94 kdx 200 top end seems flat?
Posted: 08:14 am Oct 27 2014
by Julien D
Sounds like stripped or broken sub-valves.
94 kdx 200 top end seems flat?
Posted: 07:37 pm Oct 27 2014
by SS109
Yep, I would bet money on at least one of the sub-valves are trashed.
Re: 94 kdx 200 top end seems flat?
Posted: 09:08 pm Oct 27 2014
by JoKa_603
So this means that I am screwed ? Or can I keep riding it? My understanding is that they no longer make that part

Re: 94 kdx 200 top end seems flat?
Posted: 07:50 am Oct 28 2014
by Julien D
Well the first step is going to be confirmation. You can pull the exhaust and look into the cylinder while operating the PV rod by hand.