KDXRIDER.NET

I'm taking my suspension apart and I can't get the inner tube out! The manual says just pull it... I have been but she won't come out! I'm doing seals and race tech springs.

Hi, you have an '06 200 with conventional forks? I think you need to remove the damper rod first. A 27mm(29mm for E conventional forks) nut welded to the end of an "18 T bar to hold the damper from the inside. Loosen off the bottom to remove the valving. Damper spring and rod come out the top. Only then can they be separated. Check page 3-4 of my sig suspension thread

http://www.kdxrider.net/forums/viewtopi ... 5&start=60

Damper rod and the circlip under the dust seal that sits right above the fork seal.


Sent from my iPhone using Tapatalk

Inner fork tube or damper rod?

Did you remove the cartridge?

Did you remove the circlip?

Wow! I bet you beat it to death.

I took it all apart properly. I just needed the dumb inverted 27mm. I have one now and will get back at it after work. Thanks guys!