KDXRIDER.NET

Hey all,

New to the bike. It's a 220. Full FMF pipe and header. It seemed to be set up a little rich. But is any spooge leaking out the header at the engine normal? Any ideas if it's not? New gasket or something?


Thanks for the help!

T

it should not come out the header

there are 3 parts to the seal, there is a copper gasket that sits in the cylinder, sandwiched between the head of the pipe and the cylinder itself

on the head of the pipe there are 2 O ring style gaskets

and the two springs keeping the pipe in place

I would check the springs, make sure they are still tight and replace if necessary
lots of people will also apply a thin coat of high temp RTV over the O rings to get a better seal

Thanks! That's what I thought. I will remove it and replace everything. I assume FMF sells the o rings etc?

T

Fmf sells the o rings. You may also find them at Rocky Mountain ATV.

Thanks! I will order them up!

T

Not to dredge this up again..... But can the spooge out the pipe be due to a leaking main seal ? Sorry if this is crazy......

T