KDXRIDER.NET

Just something I used on our bikes to keep any dust , water , ect. out of the tranny vent hose.
The hose inserts in the hole you can see in the front of the air box.

I zip tied a microphone foam cover on to the end of my hose, ill see it get a little dusty on the foam, after a while

I would find this particularly useful considering the previous owner had cut holes in the air box

Gotanubike wrote:I would find this particularly useful considering the previous owner had cut holes in the air box

If you're referring to the air box lid, most either drill holes in it or toss it altogether...if not on the lid then yeah and you ll want to fix that.

Lol no I mean 1 and 1/2 squares cut out of each side

http://www.kdxrider.net/forums/gallery/ ... age_id=331

that s what i was afraid of

Neat idea. Thanks for sharing.

Gotanubike wrote:I would find this particularly useful considering the previous owner had cut holes in the air box

Either use some GOOP or Permatex RT. Stuff to glue a black cover on each side.

or get a new airbox, they can be pretty cheap on fleabay.

Yeah I will patch with some ol' JB weld and a piece of plastic of similar size to fill it. One of these days when it gets warmer ..

Either way I'll add this mod for the CCV hose, maybe not one of those fancy little filters but I'll Macgyver a piece of sponge or something

It's a Napa 3011 filter cut off ..... $4.00 +/-

Many companies make the same thing . My local dollar store has them for small engine use , as it's a fuel filter.

Jason wrote:Neat idea. Thanks for sharing.

Thanks , just very picky about not getting dirt and water into the tranny oil.

yaaaa, I found my vent line missing, and exposed to all the nasty stuff the rear wheel kicks up. :-(

routed a new line way up there by the radiator, with a 3" drop to prevent ingress.

I like the ideas with the filter, looks good!