KDXRIDER.NET

Would I be able to put 95 KDX 200 plastics on my 91 KDX 200?
The stock plastics for a 91 look kinda ugly to me

Not in any way I can think of. But wadda I know? I think the E series is a nice looking bike.

You might could rig the side panels on and use an MX style rear fender, but it'll look goofy since it won't match the airbox or frame rails. The 95+ is a perimeter framed bike, completely different than the single down tube E bike.

Well I'm looking for the rear fender without the tail light

If the 1988 / 1989 KX rear fender doesn't do it, then get to doing a LOT of cutting and hacking.

I've got a mx style rear on mine. It's UFO in make.

I'm pretty sure 88-05 KX500 is the exact fit model you are looking for.

Would they fit on my bike nicely or no?

Yes. Should be a fit.

Checked to see what exact model my rear fender is and it is just stamped 'KX'.

Would the side panels for too? Like the number plates? And look good? Lol

Yes, the 88-05 KX500 side panels will fit the '91 E-series KDX. They will look exactly the same, because both models share the exact same side panel.

Would the shrouds from a 94 KDX 200 fit or no

Yes. 89-94 all have the same plastic.

The ones I'm looking at say from 94-08

Part number is: KA02787-026

I would guess that they meant to say 95-06. The 94 and 95 have different plastic. And the last year of the KDX was 06.

So they wouldn't fit -__-