Page 1 of 1
Shift Lever Adjustment
Posted: 09:49 pm Dec 04 2012
by mohawkman2
I have a 2005 KDX 200, is there any possible way to adjust the height of the stock shift lever.
Re: Shift Lever Adjustment
Posted: 10:02 pm Dec 04 2012
by diymirage
undo the pinch bolt, pull it off of the shaft, rotate it to where you want it and put the bolt back in
thats all ther is too it
Re: Shift Lever Adjustment
Posted: 10:47 am Dec 06 2012
by skippypinecone
I believe I had to file a little bit of the square area off of the outside of the lever where it attatches to the shaft to get my lever where it felt good, will rub on the case if you drop it to low and don't remove some material.
Re: Shift Lever Adjustment
Posted: 02:15 am Dec 07 2012
by gwynfryn
skippypinecone wrote:I believe I had to file a little bit of the square area off of the outside of the lever where it attatches to the shaft to get my lever where it felt good, will rub on the case if you drop it to low and don't remove some material.
Same here.