Page 1 of 1
Fork cartridge tool
Posted: 03:58 pm Jul 13 2012
by terminatr
Hey. I try to buy the fork cartridge tool from Fredette. But it seems it's out of stock for weeks. And he said, it'll be "a while". Sounded like the tool might never be back in stock. Anyway, anyone got a photo of what the tool look like? I'd like to make my own, so I can rebuild the fork.
Fork cartridge tool
Posted: 04:20 pm Jul 13 2012
by CoronasAndChips
Fork cartridge tool
Posted: 04:38 pm Jul 13 2012
by KDXGarage
FRP's tool is hollow with a 27mm nut on one end and 30mm on the other (1986 - 1992 KDX200). I have one, and it works great.
Fork cartridge tool
Posted: 05:47 pm Jul 13 2012
by terminatr
That tool says it's for damper rod fork. But I think my KDX has the cartridge type fork.
Fork cartridge tool
Posted: 06:09 pm Jul 13 2012
by scheckaet
H model 95-06 are all the same...
Fork cartridge tool
Posted: 07:25 pm Jul 13 2012
by Mr. Wibbens
Sell ya mine, make an offer
Fork cartridge tool
Posted: 09:11 pm Jul 13 2012
by KDXGarage
The 27 mm end is for 1995+/ The 30mm end is for 1986 - 1992 KDX200.
Fork cartridge tool
Posted: 06:02 pm Jul 14 2012
by terminatr
Mr. Wibbens wrote:Sell ya mine, make an offer
You got a Fredette?
Re: Fork cartridge tool
Posted: 09:40 pm Jul 14 2012
by canamfan
I welded a nut on the end of a piece of conduit and a long bolt on the other end like a t handle. I can't remember what size the nut was, I found one that looked close and ground the sides down till it fit. Crude but works well.
Fork cartridge tool
Posted: 10:32 pm Jul 14 2012
by Mr. Wibbens
terminatr wrote:Mr. Wibbens wrote:Sell ya mine, make an offer
You got a Fredette?
yessiree
Fork cartridge tool
Posted: 12:09 pm Jul 15 2012
by terminatr
$10