Page 1 of 1

brains trust.................bore diagnois

Posted: 06:16 am Jun 22 2011
by trailcutter
hi green men

well finally got round to pulling down the little green zinger.

seeking some diagnostic assistance.

2003 -200

2950 kilometres....... u do the math :wink:

following photo,s show leading -lower face of bore.
Image
Image
Image
piston / ring gap/ bore all measured up well inside spec...

no percievable deformation can be felt or measured on the sight of wear.

what is the diagnosis regarding ,,the wear pattern..

cheers

Posted: 06:20 am Jun 22 2011
by Julien D
looks like scuffing on the exhaust side. Part of what you see is probably aluminum deposits from the piston skirt. You can probably clean it up some with a schotchbrite pad and plenty of elbow grease or some muriatic acid.

All in all, looks ok.

Posted: 06:28 am Jun 22 2011
by KarlP
How does the piston look? It does look like scuffing from the lower ring down.
The cross hatch looks odd to me.

Fresh piston and rings, good for many more miles.

slug

Posted: 06:55 am Jun 22 2011
by trailcutter
here ya go!

front piston...........cheers
Image
Image

Posted: 11:34 am Jun 22 2011
by Mr. Wibbens
nice "non blurry" pics :supz:

Posted: 12:00 pm Jun 22 2011
by Julien D
Looks like you might have had some overheating going on at some point. Whatever happened, the cylinder does not appear to be damaged, so that's good. :partyman:

Posted: 04:52 pm Jun 22 2011
by trailcutter
>|<>QBB<
juliend wrote:Looks like you might have had some overheating going on at some point. Whatever happened, the cylinder does not appear to be damaged, so that's good. :partyman:

cheers mate........much oblidged :cool: