KDXRIDER.NET

Hi all.
Just wanted to pass on some info I had been searching for that may help others.
I was looking to do my top end soon and the cylinder bolts have got me to thinking how I can use my torque wrench with my crow-foot wrench ends as it looks like regular sockets cannot be used.
I found this site that lets you choose the torque needed and length of crow-foot and then tells you what you should tune your torque wrench to.
Hope it helps.
Ditton

http://www.belknaptools.com/extcalc.asp

Good stuff.

are the value in inches, mm or cm? the torque in Nm or ft lb? thanks.

Thanks! I have been looking for something like that.

Use the same values. Metric or imperial. Do not mix them up

Okie. thanks. great site.

I just learned what a torque wrench was back when I first got my KDX from Fuzzy, and Vince was helping me get her rockin'.

This helps a ton!