Posted: 07:58 pm Nov 27 2005
That's what my manual says... 
Yeh, as far as my 220 goes. I went out and did alittle counting on the sprokets lastnight.NM_KDX200 wrote:I think I have 13/49, too. Stock is 13/47, right?
Jon.
KDXRIDER.NET
Discussion group for KDX enthusiasts
https://kdxrider.net/forums/
Just a few comments....
Page 2 of 2
Posted: 08:22 am Nov 28 2005
Jon.
Posted: 03:54 pm Mar 01 2006
Just looking to srt my kdx220sr chain and sprockets, it comes with a 13x42 as standard. My KDX200 was on 13x46 and was about right for the enduros I do, only used 1st when completely stuck and never got past 4th on open stuff.
Any ideas if this would be same on a 220, i believe it is supposed to have more low down grunt so if a 46 was ok on a 200 I don't see why it would be an issue on a 220, a 48 might just take me further up the box for no benefit?
Anyone got any torque curves for a 200 vs 220?
Any ideas if this would be same on a 220, i believe it is supposed to have more low down grunt so if a 46 was ok on a 200 I don't see why it would be an issue on a 220, a 48 might just take me further up the box for no benefit?
Anyone got any torque curves for a 200 vs 220?