rubber cap for swingarm bolt, part number?

[chadr]

I have new swingarm bearings to install. I'd like to get one outside rubber cap so I have two to put back in place one the new bearings are in. I only have one of the caps on the bike now. Can't find anything on the parts diagram. Anyone have an idea?

http://www.ronayers.com/Fiche/TypeID/26 ... /Swing_Arm

Thanks.

[SS109]

Look under "frame fittings". Number 11012 on the diagram.

http://www.ronayers.com/Fiche/TypeID/26 ... me_Fitting

[chadr]

thanks - I missed that even though I must have looked at that diagram for a few minutes. My bike has the right side cap. The left side doesn't appear to show a cap though I'm sure they are the same. Would there be a reason to have only one cap?

[SS109]

Would there be a reason to have only one cap?

Not that I can think of. However, Kawasaki didn't feel the need so we only got one. I plan on capping the other side myself.

[H Muz]

Resurrecting an old thread. Interestingly the H series doesn't list this rubber cap on the parts diagram. However my 2004 came with one on the right side only. I can only assume they cancelled the cap on the H series, yeh? And previous owner slipped one on from a E series.

KDX2000-Swingarm Cap.jpg (45.65 KiB) Viewed 1488 times

[MoonStomper]

As a former technical writer I can add, ‘things get missed’.
We do our best.

I’ve found a few items missing from the parts diagrams on my H model KDX and my 2011 Vulcan 1700 as well as my Husqy chainsaw and many other machines.

[H Muz]

Ok cool thanks. So as a technical writer did you go back after and add in the missing things? ;)

[Slick_Nick]

My 2000 220 has caps on both sides. They are both shown in the "Frame fittings" diagram for that bike. Still have them in place.

11012-1591 "CAP, AXLE NUT"

[Slick_Nick]

Resurrecting an old thread. Interestingly the H series doesn't list this rubber cap on the parts diagram. However my 2004 came with one on the right side only. I can only assume they cancelled the cap on the H series, yeh? And previous owner slipped one on from a E series.

KDX2000-Swingarm Cap.jpg

You should have caps on both sides.

[H Muz]

Ahh cool thanks, have now found it. Was under 'Engine Mount" on the 2004 KDX200, cheers.