Crankshaft question ?

[Ca94cr250]

Does anybody know what other year kdx 200 crankshafts are interchangable with the 1990 model ?

[turtle]

I do not. But you should be able to go to cheapcycleparts.com to their parts listing and identify the part number. Then you can go back here http://www.cheapcycleparts.com/oemparts ... ycle/parts, plug the part number in, and see all the years and models it was used. Hopefully that helps.

[Ca94cr250]

Much appreciated !

[Julien D]

They changed the nuts/bolts on the ends of the crankshaft sometime during the E series reign. You can use earlier or later type in any E bike but you might need the primary gear, nut, and the nut for the flywheel side as well, depending on which you have and which you are going to. I THINK the earlier model is inside thread for a bolt on the flywheel side, and later model is outside thread for a nut. Been a while since I looked into this, so make sure you do some research first! No clue on using an H series crank, but I considered it at one time, and I believe it would be possible with the right combination of primary gear, nuts, and bolts.

[Ca94cr250]

Perfect thank you !