E series fork question
-
- Supporting Member II
- Posts: 674
- Joined: 07:54 am Jun 26 2012
- Country:
- Location: Rhode Island
E series fork question
I have the compression adjuster loose on the bottom of the fork, but I can not get the forks apart. It will not come out any further. It just spins. Is it supposed to come out all the way and then pull the sliders apart?
- KDXGarage
- KDXRider.net
- Posts: 14119
- Joined: 06:45 am Nov 01 2004
- Country: United States of America
- Location: AL, USA
- Contact:
Re: E series fork question
You are supposed to use a tool to hold the damping rod still to allow the adjuster to loosen. Also, be sure the circlip is removed from the seal/bushing area.
Thank you for participating on kdxrider.net.
To post pictures from a device: viewtopic.php?f=88&t=24128
To post pictures from a device: viewtopic.php?f=88&t=24128
-
- Supporting Member II
- Posts: 674
- Joined: 07:54 am Jun 26 2012
- Country:
- Location: Rhode Island
Re: E series fork question
The clip is removed and adjuster is loose. Should the adjuster come out of the lower fork tube before they seperate?