So I recently rebuilt my 88 using the new wiseco piston released, along with a re sleeve and all relating bearings seals etc.
The bike has great torque and pulls well into the top end
I also installed the Boyesen reeds.
Does anyone have experience with jetting issues as the bike over revs on overrun especially when negotiating long rock decents.
She hunts for a while before revving high for approximately 10 seconds.
It sounds like it's leaning out as if the fuel tap was off. Def no air leaks present.
Cheers
Gazza
KDX C Model Jetting
-
- Supporting Member
- Posts: 44
- Joined: 03:06 pm Feb 03 2015
- Country:
- Location: Sunny Andover UK.
KDX C Model Jetting
Float height?
-
- Member
- Posts: 6
- Joined: 12:43 am Mar 14 2015
- Country:
KDX C Model Jetting
Cheers !
Was a bit low, also found the main jet cracked 90% around where thread meets jet body.
Guessing it's been over tightened.
Regards
Was a bit low, also found the main jet cracked 90% around where thread meets jet body.
Guessing it's been over tightened.
Regards